(a.) Easily led; tractable; complying; yielding to motives, persuasion, or instruction; as, a ductile people.
(a.) Capable of being elongated or drawn out, as into wire or threads.
Example Sentences:
(1) Mechanical and biomechanical testing of a new bone cement suggests that improved load transfer to the proximal femur could be achieved with the combination of a cement having a lower modulus, a greater ductility and a lower creep resistance than polymethylmethacrylate and a suitably shaped femoral component.
(2) The above materials were generally ductile and the mechanical properties indicated a useful class of materials for clinical use.
(3) Results indicated that excellent welds can be obtained with very little loss of strength and ductility in the area of the weld joint.
(4) These materials could not be used in load-bearing applications because of the excessive grain growth and loss of the wrought structure of both the commercially pure Ti and Ti-6Al-4V substrates, and the loss of ductility in the cast Co-Cr-Mo alloy.
(5) Cast and hot isostatically pressed Ti-6Al-4V, however, has a relatively low ductility and reduced fatigue properties.
(6) Furthermore, it has been shown that the attainment of suitable strength is invariably associated with an unacceptable level of ductility.
(7) The effect of stress on a cantilever, consisting of a ductile alloy in contact with a brittle polymer, was demonstrated to be complex.
(8) The presence of the urethane bond at the N-terminus protecting group was found to reduce solubility, ductility, and processibility, probably due to interchain hydrogen bonding.
(9) Analysis of the stress-strain curves revealed a transition in the type of deformation at this point from pseudo-ductile to brittle.
(10) This composition is consistent with the hypothesis that the cement line provides a relatively ductile interface with surrounding bone matrix, and that it provides the point specific stiffness differences, poor 'fiber'-matrix bonding and energy transfer qualities required to promote crack initiation but slow crack growth in compact bone.
(11) The parameters used to assess performance were sharpness, resistance to bending, and ductility.
(12) maize starch and polymeric materials, there was an increase in the yield pressure with punch velocity attributable to a change either from ductile to brittle behaviour or a reduction in the amount of plastic deformation due to the time dependent nature of plastic flow.
(13) The purpose of this research was to evaluate the torsional strength and ductility of CP titanium in the as received condition, heat treated below the alpha----beta transition temperature, and glass bead blasted.
(14) In the present effort, the same flexure tests were reevaluated to include the parameters of stiffness, toughness, and ductility.
(15) The proximal end is ductile and the distal end rigid.
(16) A more ductile PLLA exhibiting a lower rate of degradation was prepared by extraction of low molecular weight compounds with ethyl acetate.
(17) The ductility and malleability of pure silver allow for ease of adaptation or alteration as a chairside or operating room procedure.
(18) (3) The simulated ceramic firing cycle created a small amount of ductility in SMG-2, but the lowering of the yield stress in Ceramco-0 renders the welds dangerously weak even with improved ductility.
(19) The fracture of the titanium specimens was ductile, with dimples occurring at the fracture surfaces.
(20) The superior ductility of needles made by one manufacturer was related to the specific alloy, stainless steel ASTM 45500, used in their production.
Tensile
Definition:
(a.) Of or pertaining to extension; as, tensile strength.
(a.) Capable of extension; ductile; tensible.
Example Sentences:
(1) Experiments have been performed using CO2 laser-assisted microvascular anastomoses, and they demonstrated the following features, in comparison with conventional anastomoses: ease in technique; less time consumption; less tissue inflammation; early wound healing; equivalency of patency rate and inner pressure tolerance; but only about 50 percent of the tensile strength of manual-suture anastomosis.
(2) A logarithmic relationship between closing tension and tensile strength was demonstrated using linear regression analysis with t = 6.18, p less than .0001, and R2 = .44.
(3) This could be explained by the different tensile properties of the two types of grafts.
(4) Therapeutic doses of cHyp in liposomes injected for 6 months affected tensile properties of main pulmonary artery and aorta, but there were no apparent histological effects on other organs.
(5) After the tensile test the residue of the bonding agent on one surface of the test-piece pairs, always remained significantly higher, than on the other, but this phenomenon cannot be explained by the differences between R(a) and Rmax within the test-piece pairs.
(6) Alternatively, a loss of collagen tethers or decline in matrix tensile strength can be responsible for regional or global transformations in myocardial architecture and function seen in the reperfused ("stunned") myocardium and in dilated (idiopathic) cardiopathy.
(7) Proof stress, ultimate tensile strength, elongation, and plastic stiffness have been measured and results compared by use of analyses of variance.
(8) Dexon's tensile strength is high initially and it retains its strength through the critical period of muscle-scleral wound healing, then dissolves in a rapid uniform manner.
(9) The mechanical properties of compressed beam specimens of microcrystalline cellulose (Avicel pH 101) have been assessed in terms of the tensile strength (sigma t), Young's modulus (E) and the following fracture mechanics parameters: the critical stress intensity factor (KIC), the critical strain energy release rate (GIC) and the fracture toughness (R).
(10) It was found to be 35% of the static tensile strength and greater than 0.6 Nmm-2 within a 95%-safety-range.
(11) The growth of the host tissue occurred in and around a Leeds-Keio ligament in response to tensile stresses.
(12) (2) The effect of the addition of In and Sn to the tensile strength depended on the concentration of Pd and Ag.
(13) Incorporating polyvinylpyrrolidone, gelatin and methylcellulose binding agents in a metronidazole formulation alters the tensile strength, disintegration and dissolution times of the tablets by reducing their wettability as measured by the adhesion tension of water.
(14) The tensile bond strengths of the bonding resin to the etched enamel surfaces were not significantly different.
(15) A corrugated appearance of the patellar tendon on sagittal images indicates a reduction in the normal tensile force applied to it and indicates the need for careful evaluation of the patella and quadriceps tendon mechanism.
(16) The peak tensile strength of the reconstructed ligament was about one third of the paired normal ACL ligament during the 16 week experiment.
(17) The purpose of this in vitro study was to determine the tensile bond strengths (TBS) of several orthodontic bonding systems and orthodontic brackets to enamel surfaces exposed to different etching procedures.
(18) There are no significant differences of shrinkage temperature and ultimate tensile stress among all tissue samples pretreated with GA, EP 1# and EP 2#.
(19) Testing the bone models to failure in tensile mode showed that the perforations weakened the bone and that the Partridge plates and bands decreased the weakening effects of the perforation.
(20) In some cases, one or more microsurgical epiperineurium-fascial stitches (EPFS) along the proximal and distal stumps of a transected nerve permit their firm approximation, shifting tensile forces from the suture line over longer segments of the nerve stumps.