(1) Seven patients (12.5%) developed LAH between the first and third hospital day, while 49 patients did not.
(2) Fibrin deposition, assessed both by immunohistology and quantitation of radioactive fibrin extracted from skin test sites, was increased by 30% when OVA was tested in the presence of LAH.
(3) Interferon-gamma (IFN-gamma) production is severely defective in L-LAK-HCC but not defective in H-LAH-HCC.
(4) According to the results of electrocardiogram patients were subdivided into 4 groups: normal electrocardiogram, isolated left auricular hypertrophy (LAH), isolated left ventricular hypertrophy (LVH) and major ST-T wave changes.
(5) Of these, five had electrocardiographic bifascicular block (RBBB with LAH) with or without additional 1 degrees A-V block.
(6) Attention has been called to the fact that, with the onset of LAH conduction, the T-wave axis shifts oppositely to that of the QRS, thus widening the QRS-T angle in the frontal plane by about 95 degrees.
(7) LAH has been shown to conceal LVH on precordial leads, while it tends to make LVH more manifest on limb leads.
(8) One connection between sport and fashion writing is that they come with very lazy gender assumptions: sportsing for the boys and lah-di-dah clothes for the gals.
(9) The incidence of left anterior hemiblock (LAH), right bundle branch block (RBBB), left bundle branch block (LBBB) and RBBB+LAH was 12.2, 4.2, 3.8 and 2.5%, respectively.
(10) Recurrent pump failure with occasional outcome is more common in cases with RBBB and LAH than in other types of blocks.
(11) T-waves are lowered but not inverted in lead I as a result of LAH conduction and precordial leads are variably but not significantly altered.
(12) Ninety-four percent had developed right bundle branch block (RBBB) and 16 percent had additional left anterior hemiblock (LAH).
(13) 131 subjects were studied: 34 of them were normal (control group); 30 were carriers of isolated LAH; 38 were carriers of isolated LVH; 29 showed a pattern of combined LVH and LAH.
(14) The time course of laccase production by the lah-1 mutant revealed that expression of 66-kilodalton laccase was repressed in conidia and derepressed during vegetative mycelial growth.
(15) Among these 53 LAH patients, only 20 desired a pregnancy.
(16) The critical factor in a bad late prognosis in patients with ECG evidence of RBBB and LAH may be with ECG evidence of RBBB and LAH may be the history of transient postoperative CHB.
(17) In the LAH + RBBB group, there was a higher mortality rate and frequent evolution toward complete A-V block.
(18) Slow depolarization elicited by repetitive activation of splanchnic and coeliac nerve trunks, at voltages supramaximal for the fast cholinergic responses, were recorded from about half of both phasic and tonic neurones, but only one of twenty-four LAH neurones.
(19) The relations between LAH and clinical, echographic and hemodynamic findings are specified.
(20) Relative amounts of laccase in the culture filtrate of the lah-1 mutant were much higher than those induced with cycloheximide in the wild-type strain, demonstrating high efficiency of the lah-1 mutant in production and secretion of laccase.
Lath
Definition:
(n.) A thin, narrow strip of wood, nailed to the rafters, studs, or floor beams of a building, for the purpose of supporting the tiles, plastering, etc. A corrugated metallic strip or plate is sometimes used.
(v. t.) To cover or line with laths.
Example Sentences:
(1) One had been attached to the first cutting lathe that Optimal had acquired.
(2) Through combination with a spherical disc face perpendicular to the axis of rotation, which protrudes only slightly from the hemispherical catheter tip, with a maximum at the center and minimum at the lateral borders, the lathing head has only a slight risk of perforation and no undesired sheering forces (Figures 2a to 2d).
(3) Machinable ceramics that can be cut and even lathed have recently been developed in industry.
(4) We studied the anterior surfaces of 30 soft contact lenses (10 lathe cut [polished]; 10 spin cast [unpolished], and 10 cast molded [unpolished]) of the same polymer and water content.
(5) The results indicate that when dental amalgam alloy is added to the glass ionomer, lathe-cut particles are to be preferred but only in an amount up to 20% by weight.
(6) Changes in corneal curvature and subjective refraction were found to occur in some wearers of N & N lathe-cut soft contact lenses.
(7) Peripheral swelling was less than central for both lathe cut- and spun cast-type lenses.
(8) For clinical application the initial intumescence should be taken into consideration, as well as the donor tissue thickening during its freezing for working on a lathe.
(9) Data is presented in respect of 256 restorations of Occlusin and 69 restorations of a conventional lathe cut amalgam.
(10) The lenses studied were lathe-cut polymethylmethacrylate (PMMA), injection-molded non-UV PMMA, injection-molded UV PMMA, and cast-molded UV PMMA.
(11) Measurement of the corrosion rates of three distinctive amalgam alloys (lathe-cut, spherical and dispersed-phase) when immersed in three different electrolytes, including saliva, is reported.
(12) The results indicated that early microleakage from alloys of lathe-cut particles was lower than that from alloys of spherical particles in both low-copper and high-copper amalgam restorations.
(13) Precise lathing of epikeratoplasty lenticules is difficult to achieve with the cryolathe due to unpredictable expansion of the lathing tools and the corneal tissue during the freezing process.
(14) Like, ‘Don’t send us a CD master of the loudest techno music and expect that to be cuttable on a lacquer.’ (The high and low frequencies associated with this type of music can overheat the cutting lathe and cause the mastering machinery to shut down; pushing the process to its limits is the origin of some records being called “hot cuts”.)
(15) Often overlooked is the dental laboratory of which particular interest focuses on the lathes used in preparing prosthetic appliances, castings, orthodontic appliances, and surgical stents.
(16) A method was developed for lathing corneal tissue without freezing.
(17) This paper describes in detail the geometry of the first lathe-cut hydrophilic lens approved by the Federal Drug Administration, the fitting methods utilizing trial lenses, and the results of 100 patients successfully fitted.
(18) We adapted a lathe to the production of keratolenses.
(19) USA 69, 3643-3647) and the HLP-1 protein (Lathe, R. et al.
(20) Three out of 10 eyes (30%) in which injection molded anterior chamber lenses from McGhan were used developed cystoid macular edema, compared to a much lower incidence with the use of lathe-cut anterior chamber lenses from Rayner.